What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 19.06.2025 01:18

“ A fuse is a device which protects the (circuit) against overload and short circuit.”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
One is “what exactly is in a ‘surge protector’ ? ”
What is a common thought that keeps people up at night? Why do some people experience this?
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
He then describes Rainy Season and Lightning.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
How do you perform a lap dance for your boyfriend or husband?
Edit 2024–10.
This one hit behind the barn.
A circuit breaker is similar, but is resettable.
Appendix Cancer Rates Climb Among Millennials and Gen X - Newser
(Dc diagram shown, AC is similar).
nine
But… the neutral is now “floating” because of the 1 ohm resistance.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
There are three different concepts here that are getting confused.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Because the load is inductive, the current lags the voltage.(by a bit).
He then describes the function of a fuse.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
It also is a device that limits the change in current flow.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
How can I get my ex-husband to love me again?
It seems Mohan does not understand the difference between a comment and an Answer.
Barnstars:
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
The third is lightning and “how it gets conducted into a home.”
What does a fuse do?
So, the voltage could go up to 500 volts, and the fuse will not open up.
the problem then depends on "how fast does the fuse operate?".
The other is “what does a “fuse” do?”
A fuse is a non-resetable over current circuit protector.
What would explain Trump blaming Ukraine for starting the war with Russia?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
One
First Sentence:
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then asserts :
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
At one ohm, the resistor has a maximum of 1 watt power.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
What is lightning?
This is where the MOV conducts again, and dissipated the energy.
I post the exact comment here.
These devices are installed between the “hot” and “neutral” and protective ground.
Upvotes:
At least they know the answer if they wanted it.
so, what happens?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
what exactly is a ‘surge’ protector?
This is 'the assistant's answer'
but I think this circuit , shows a few more pieces.
This is where this question deviates from being a 'generic' question, and becomes more specific.
But it can get overloaded, and no longer works.
There are two important concepts here.
The bolt then partially travels down the line to your home.
2024–10–16 [ OO OLAOYE OYEBODE ]
In schematic diagrams this is the symbol for a fuse:
[old diagram got deleted by accident]
This device then solves the entire problem.
These are simplified answers to the original question, and does not change anything I wrote above.
[image of Common-mode choke]
2024–10–10[John johnson John Johnson ]
For this case there are devices called Metal oxide varistors (MOV).
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
a photo is worth a thousand words.
Here is a simplified AC power diagram.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
An AC voltage/ current source, and an ac inductive load.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
but this device (an Inductor) … impedes the rapid changes in the current.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
eight